Flight Controllers

• with a function of being directly plugged into the satellite receiver(It needn’t conversion cable)
• Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and 20KB RAM.
• 3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer.
• Tiny 36 x 36 mm 4 layer PCB for superior electrical noise reduction and flight performance.
• Software support for Windows, Mac, and Linux.
• Direct high-speed USB support with no drivers required, a true plug and play device.
• Spektrum satellite receiver support.
• Futaba S-BUS hardware support.
• Innovative Flexi-port technology for superior port flexibility.
• 4Mbits onboard EEPROM for configuration storage.

• Input Voltage (V): MC: 4.8V~5.5V (recommended 2S~6S Lipoly).
• Power Consumption: MAX: 1.5W (0.3A @ 5V), Normal: 0.6W (0.12A @ 5V).
• Operating Temperature:-10°C ~ +50°C.
• Supported ESC Output: 400Hz refresh frequency

1. Supported Receiver Input Signal: PPM, SBUS, DSM
2. Support PPM, SBUS, DSM receiver input signal
3. Battery voltage detection and buzzer interface
4. Run on SP RACING F3 EVO firmware 32 brush flight control
5. Large current NMOS transistors, operating current can reach 10A or higher
6. Use STM32F303CCT6 + MPU6500, advanced hardware platform F3 for higher flight stability

1. Dimensions: 37 x 37 x 10 mm(L x H x W)
2. Weight: 12 gm.
3. SPI Gyro MPU6000
4. MicroSD Blackbox
5. F4 Processor (F405)
6. 5v3a SBEC
7. Built-in Current Sensor
8. On-Board OSD (controlled by Beta flight, FC over SPI bus)
9. On-Board Video Filter (only can supply 5V to VTX and Camera)
10. On-Board Voltage Regulator and Power supply (BEC)

Features:

1. The volume of about 50 dB.
2. Interface: 1.25-2P plug.
3. Adopts E-Switch red light switch.
4. Length: 250mm .
5. Switch mounting hole diameter 8mm.
6. The same version with 3DR official version.