Showing 97–108 of 123 results
MX1919 Based Motor Driver Module – 2.5A (Upgraded Version)
PCA9685 16-Channel 12-bit I2C interface Servo PWM Driver
Specifications:
- 5V compliant, and still talks to a 3.3V microcontroller
- 6 "address select" pins for configuring up to 62 ICs on a single I2C bus
- PWM frequency adjustable up to approximately 1.6kHz
- 12-bit frequency resolution (equates to about 4µs resolution at 60Hz refresh rate)
- Configurable as a push-pull or open-drain output
- The output enables the pin available for outside-the-microcontroller "shut it down!" control.
PlayStation PS2 Receiver adaptor, 4 DC Motors & 8 PWM Servo Controls
Specifications:
- Use the TB6612 chipset to provide 1.2A (3A peak) output per channel and run a 4.5-13.5V DC motor
- Can drive 4 DC motors or 2 stepper motors
- Additional 4 PWM outputs are available to control 4 servos
- Support PS2 wireless controller
- Support Bluetooth module and ultrasonic sensor
- Customizable I2C address, supporting multiple drive stacking cascades
- Provides a complete code base and rich sample programs that are easy to use.
Refurbish DC5-30V 12V 24V 5A DC Motor Controller PWM Adjustable Speed Digital display encoder duty ratio frequency MAX 15A ZK-MG
Specifications:
- Working voltage: DC5V~30V, input anti-reverse connection protection
- Rated current: 5A maximum current 15A
- Maximum power: 150W
- Working frequency: 1KHz~99KHz adjustable, 1KHz step, default frequency of 20KHz, accuracy of about 1%
- Duty cycle: 0-100%, 1% step
- Product size: 79mm*43mm*26mm
Servo Motor ESC Tester
Specifications:
- Offer 3 modes to check servos or ESC
- Supply voltage: 4.8V-6.0V
- Output Signal: 1.5ms±0.5ms
- Three mode selection [Manual, Neutral and Auto]
- Enclosure Box
- Mode selection LED Indicator
- Adjustable Knob for manual speed control
- Operating Temperature Range: -40~+85°C
- The Manual Mode allows you to turn the knob to different speeds and check the reaction time
- The Neutral mode makes the servo go back to the neutral point
- The Automatic ’’Window Wiper’’ Mode makes the servo swing like a window wiper in the largest angle possible
- Connect to up to 3 servos simultaneously.
SimonK 30A BLDC ESC Electronic Speed Controller Without Connectors
SimonK 30A Brushless Speed Controller ESC Multicopter Helicopter Airplane – Good Quality
Specification:
- MODEL: STANDARD 30A BLDC ESC ELECTRONIC SPEED CONTROLLER
- WEIGHT: 23g
- DIMENSIONS: 45 x 24 x 9 mm(LxWxH)
- Â Color: Yellow/Red(Depends on Availability)
- CURRENT (A): 30A
- BEC: 3A
- Li-Poly: 2-3
- Ni-Mh/Ni-CD: 4-10 Ni-Mh
- CONSTANT CURRENT: 30A Max 40A<10s
- Li-Poly 2-3 CELLS; Ni-MH 4-10 CELLS Auto Detect
- Break On/Off
- Auto Low BATTERY Slow down at 3.0V/cell Lipo, cut-off at 2.9V/cell lipo
- APPLICATION: Multirotors, Rc Airplanes, etc.
SimonK 30A ESC with connectors Red
Specifications:
- High-quality MOSFETs for BLDC motor drive
- High-performance microcontroller for best compatibility with all types of motors at greater efficiency
- Fully programmable with any standard RC remote control
- Heat sink with high-performance heat transmission membrane for better thermal management
- 3 start modes: Normal / Soft / Super-Soft, compatible with fixed-wing aircraft and helicopters
- Throttle range can be configured to be compatible with any remote control available in the market.
SmartElex 10S DC Motor Driver HAT
SmartElex 15D Dual Channel DC Motor Driver
SmartElex 15S DC Motor Driver 15A (30A Peak)
