Showing 301–312 of 318 results
12V 8 Channel Relay Module (with Optocoupler)
Specifications:
- Operating Voltage: 12V DC
- Equipped with high-current relay 10A@250VAC / 10A@30VDC
- It can control both AC and DC appliances such as Solenoids, Motors, lights, fans, etc
- High-quality screw terminals (Terminal Block) provided (C, NC, NO) for quick and easy connection
- A freewheeling diode to protect your microcontroller
- Input Signal Pin connected to Burg stick for easy accessibility
- LED status indicators to indicate the relay ON/OFF status
- Mounting holes provided
SimonK 30A ESC with connectors Red
Specifications:
- High-quality MOSFETs for BLDC motor drive
- High-performance microcontroller for best compatibility with all types of motors at greater efficiency
- Fully programmable with any standard RC remote control
- Heat sink with high-performance heat transmission membrane for better thermal management
- 3 start modes: Normal / Soft / Super-Soft, compatible with fixed-wing aircraft and helicopters
- Throttle range can be configured to be compatible with any remote control available in the market.
TB6600 Stepper Motor Drivers 4A 9-42V Micro Step CNC 1 Axis
Specifications:
- DC 9-42V power supply, 12-24V power supply the best
- Control signal input voltage 3.3-24VÂ
- Segmentation accuracy 1-32 subdivision optional
- Output peak current 4.0A
- Input signal high-speed optocoupler isolation
- Built-in temperature protection and over-current protection
- Automatic half-flow to reduce heat
150 RPM L Type Bo Motor
300 RPM Straight Dual Shaft Bo Motor
60 RPM L Type BO Motor
12V 60 RPM Rectangular Gearbox Motor
12V 30 RPM Rectangular Gearbox Motor
12V 4 Channel Relay Module (with Optocoupler)
Features :
- This Board can be used to Control Solenoids, Motors, Lamps, etc,
- Input Logic: 12v level from MUC
- Indication LEDs for relay output status.• 12V 4-Channel relay board controlled directly by micro-controller (Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic) need 50-60mA driver current
- Input IN1, IN2, IN3, IN4 signal line active low, 4-channel relay output module, relay output contact is maximum 250A 10A
- Input Pin connected to Burg stick. High-current, AC250V 10A, DC30V 10A.
300 RPM Straight Single Shaft BO Motor
APM 2.8 Flight Controller with Built in Compass
Specifications :
- Straight Needle
- Arduino Compatible!
- Onboard 4 MegaByte Dataflash chip for automatic data logging.
- Optional off-board GPS, a uBlox LEA-6H module with Compass.
- One of the first open source autopilot systems to use Invensense’s 6 DoF Accelerometer/Gyro MPU-6000.
- Barometric pressure sensor upgraded to MS5611-01BA03, from Measurement Specialties.
- Atmel’s ATMEGA2560 and ATMEGA32U-2 chips for processing and USB functions respectively.