Back to products

BESTEP 8 Channel 12V Relay Module High and Low Level Trigger for Arduino 09

BESTEP 8 Channel 12V Relay Module High and Low Level Trigger for Arduino 01

Click to enlarge

BESTEP 8 Channel 12V Relay Module High and Low Level Trigger for Arduino

Features:

Maximum load: AC 250V/10A, DC 30V/10A.
The chip optocoupler isolation, strong driving ability, stable performance, and trigger current 5mA.
The working voltage is 12V.
Each channel of the module can be set up by a high jumper or low-level trigger.
Fault-tolerant design, even if the control line is broken, the relay will not act.
Power indicator (green), 8 relay status indicator (red).
The interface design is humanized, all interfaces can be directly connected through the terminals, so it is very convenient.
Module size: 142mm x 50mm x 18.5mm (length x width x height).
There are 4 fixed bolt holes, holes 3.1mm, spacing 67mm x 44.5mm.

SKU: RDNA-704.1

Apple Shopping Event

Hurry and get discounts on all Apple devices up to 20%

Sale_coupon_15

₹399.00 (Inc. GST)
₹338.14 (+18% GST Extra)

Only 2 left in stock

Compare

Add to wishlist

11 People watching this product now!

Pick up from the RoboticsDNA Store in Pune / Dunzo

To pick up today

Free

Same Day Delivery in Pune

(Mon-Sat) (Please Place Order Before 1:30 PM)

Rs. 99

via Delhivery.com (Express Mode)

Our courier will deliver to the specified address

3-5 Days

Rs. 149

via Delhivery.com (Surface Mode)

Our courier will deliver to the specified address

4-7 Days

Rs. 69

Payment Methods:

Description

Module interface:

1. DC+: Connect the power positive pole

2. DC-: Connect the power negative pole.

3. IN1-IN8: According to the setting of each way, the corresponding relay-operating can be controlled by high or low level.

Relay output: there is a 24 wire interface, all interfaces can be directly connected to lead to facilitate user use.

1. NO1–NO8: Relay normal open, the relay suspends before pulling in, and then short-connect with the COM.

2. COM1–COM8: Relay common interface

3. NC1–NC8: Relay normal close, short connected with COM before pulling inand suspended after pulling in.

High and low-level trigger option:

1. S1-S8 is the high-level trigger selection of relay 1 Channel – 8 Channel.

2. When COM is short-connected with LOW, the corresponding relay is LOW-level trigger, while when COM is short connected with high end is high-level trigger.

Packing List:

1 x BESTEP 8 Channel 12V Relay Module High and Low-Level Trigger for Arduino