Showing 1–9 of 123 results
Motor drives are circuits used to run a motor. In other words, they are commonly used for motor interfacing. These drive circuits can be easily interfaced with the motor and their selection depends upon the type of motor being used and their ratings (current, voltage).
1.5Amp 7V-25V DC Motor Driver (4 Channels)
Features:
- Bidirectional control for four (4)Â brushed DC motors.
- Operating Voltage: DC 7V to 25V
- Maximum Motor Current: 1.5A continuous, 2.5A peak
- Buttons for quick testing.
- LEDs for motor output state.
- PWM and DIR inputs.
- Inputs compatible with 3.3V and 5V logic (Arduino, Raspberry Pi, PLC, etc).
- Reverse polarity protection.
- Board size: 10.67cm x 5.21cm
10000W AC 220V Original Chips Thyristor Super Power Electronic Regulator can Change Light Speed and Temperature
10000W Super Power Thyristor Electronic Voltage Regulator, Adjust Light Speed Temperature
1203B PWM 6V 12V 24V 28V 3A DC Motor Speed Regulator
12V-24V 8A Adjustable Dimmer Switch For Single LED Strip
12V-40V 10A DC Motor PWM Speed Control Switch Governor
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
Specifications:
- Adjustable frequency PWM up to about 1.6 KHz
- 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
- Configurable push-pull or an open-drain output
- The output enable pin to quickly disable all the outputs
- Terminal block for power input
- Reverse polarity protection on the terminal block input
- Green power-good LED
170W High Power H-Bridge Motor Driver Module For NMOS Brake Duty Cycle For DC 5-40V Motor 4 External NMOS Tubes Two PWM Inputs
Specifications:Â
- With full bridge driver chip + low resistance 55V110ANMOS, the motor can be turned forward and backward.
- Two PWM inputs, dutycycle regulated in 0-100%. Instant braking ability.
- The working voltage is 10-40V and the power is below 170W
- The control is simple and convenient. Only 3 input lines are needed to control the motor
- Chip built-in dead time hardware control, more suitable for frequent reversing. Reduce the loss of the pipe itself.
- Tin plating on the back of the module. A conductor can flow through a larger current.
- Support 5V, 3..3V logical input. Suitable for all types of single-chip IO port direct control. You can also control the positive and negative rotation of the motor by analog input.
- Board size: 38.8*67.5mm
