Showing 1–18 of 66 results
2531 Transistor Output Optocoupler
74HC4052N IC
Features:
- Type: Dual 4-channel analog multiplexer/demultiplexer IC
- Technology: CMOS (Complementary Metal-Oxide-Semiconductor)
- Number of Channels: 2 channels, each with 4 multiplexed inputs/outputs
- Operating Voltage: Typically operates at 2 to 6 volts
- Logic Compatibility: TTL (Transistor-Transistor Logic) and CMOS compatible
- Package: DIP (Dual Inline Package) or SOP (Small Outline Package)
- Applications: Used for signal routing, analog signal switching, and multiplexing/demultiplexing in various electronic circuits.
74LS244 IC – Octal Buffer/Line Driver with Tri-State Output IC (74244 IC)
Features:-
- Supply Voltage: 7V
- 3-STATE outputs drive bus lines directly
- Â PNP inputs reduce DC loading on bus lines
- Â Hysteresis at data inputs improves noise margins
- Typical IOL (sink current) 24 mA
-  Typical IOH (source current) −15 mA
- Â Typical propagation delay times Inverting 10.5 ns Noninverting 12 ns
- Â Typical enable/disable time 18 ns
- Â Typical power dissipation (enabled) Inverting 130 mW Noninverting 135 mW
7873 IC
Features :
- 4-wire touch screen interface
- On-chip temperature sensor: −40°C to +85°C
- On-chip 2.5 V reference
- Direct battery measurement (0 V to 6 V)
- Touch pressure measurement
- Specified throughput rate of 125 kSPS
- Single supply, VCC of 2.2 V to 5.25 V
- Ratiometric conversion
- High speed serial interface
- Programmable 8-bit or 12-bit resolution
- One auxiliary analog input
- Shutdown mode: 1 µA maximum
- 16-lead QSOP, TSSOP, and LFCSP packages
817C Optocoupler DIP IC
AD620AN IC
Features:
- Easy to use
- Gain set with one external resistor (Gain range 1 to 10,000)
- Wide power supply range (±2.3 V to ±18 V)
- Higher performance than 3 op-amp IA designs
- Available in 8-lead DIP and SOIC packaging
- Low power, 1.3 mA max supply current
- Excellent dc performance (B grade)
- 50 μV max, input offset voltage
- 0.6 μV/°C max, input offset drift
- 1.0 nA max, input bias current
- 100 dB min common-mode rejection ratio (G = 10)
- Low noise
- 9 nV/√Hz @ 1 kHz, input voltage noise
- 0.28 μV p-p noise (0.1 Hz to 10 Hz)
- Excellent ac specifications
- 120 kHz bandwidth (G = 100)
- 15 μs settling time to 0.01%
AMS1117-3.3V, 1A, SOT-223 Voltage Regulator IC (Pack of 5 ICs)
AO3400 30V 5.8A N-Channel MOSFET SOT-23 (Pack of 5)
ATtiny13 IC
Specification:
- 1K byte of In-System Programmable Flash,
- 64bytes EEPROM, 64 bytes SRAM,
- 6 general purpose I/O lines,
- 32 general purpose working registers, one 8-bit Timer/Counter with compare modes,
- Internal and External Interrupts,
- a 4channel, 10-bit ADC, a programmable Watchdog Timer with internal Oscillator,
- three software selectable power saving modes.
- The Idle mode stops the CPU while allowing the SRAM,
ATtiny85 IC
BT 136 IC NXP
Specifications:
• High blocking voltage capability
• Low holding current for low current loads and lowest EMI at commutation
• Planar passivated for voltage ruggedness and reliability
• Sensitive gate
• Triggering in all four quadrants, Direct triggering from low power drivers and logic ICs
CH340G SOIC16 USB to Serial TTL-RS232 converter IC
Features:
- Full speed USB device interface, conforms to USB Specification Version 2.0, only needs crystal and capacitance external.
- Emulate standard serial interface, used to upgrade the former peripheral device, or add excess serial interface through USB.
- Compatible with serial application program in a computer endpoint Windows operation system.
- Hardware full duplex serial interface, set transceiver buffer, supports communication baud rate varies from 50bps to 2Mbps.
- Supports common MODEM liaison signal RTS, DTR, DCD, RI, DSR and CTS.
- Through adding level converter equipment to supply RS232, RS485, RS422 and another interface.
- Supports IrDA criterion SIR infrared communication, supports baud rate varies from 2400bps to 115200bps.
- For it is through USB converts to the serial interface, only compatible with application layer not totally.
- Software compatible with CH341, using the drive of CH341 directly.
- Support 5V and 3.3V source voltage.
- Supply SSOP-20 package without lead, compatible with RoHS
CHN TL082CN IC
Specifications:
- The general-purpose dual j-fet operational amplifier
- low power consumption
- wide common-mode (up to vcc+) and differential voltage range low input bias and offset current output
- short-circuit protection
- high input impedance
- jÂfet input stage internal frequency compensation
- latch up free operation
- HIGH SLEW RATE : 16V/µS (TYP)
CQ1265RT IC
Features:
• Optimized for Quasi-Resonant Converter (QRC)
• Advanced Burst-Mode Operation for under 1W Standby
Power Consumption
• Pulse-by-Pulse Current Limit
• Over Load Protection (OLP) - Auto Restart
• Over Voltage Protection (OVP) - Auto Restart
• Abnormal Over Current Protection (AOCP) - Latch
• Internal Thermal Shutdown (TSD) - Latch
• Under Voltage Lock Out (UVLO) with Hysteresis
• Low Startup Current (typical : 25uA)
• Internal High Voltage SenseFET
• Built-in Soft Start (20ms)
• Extended Quasi-Resonant Switching
D2498 IC
D2499 IC
