PICKIT 3.5 Debugger / Programmer

Features:

1. Operating Voltage: 1.5～5V JTAG IO Voltage.
2. System configuration: Windows XP, Windows Vista, Windows7, USB interface.
3. Stably support SignalTap II embedded logic analyzer function, no mistake while crawling data.
4. Fully support all Altera products such as CPLD: MAX3000, MAX7000, MAX9000 and MAXII.
5. FPGA: Stratix, StratixII, StratxIII, Cyclone, CycloneII, CycloneIII, ACEX1K, APEX20K and FLEX10K etc.
6. Active serial configuration device: EPCS1, EPCS4, EPCS16, EPCS64 etc.
7. Enhanced configuration devices: EPC1, EPC4.
8. Supports 3 download mode: AS, PS and JTAG.

Specifications:

• Chip type: W5500
• Supports both 3.3V & 5V
• Hardwired TCP/IP Protocols: TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
• 10BaseT/100BaseTX Ethernet PHY embedded
• Supports automatic response (full duplex/half duplex mode)
• Supports 8 independent sockets simultaneously
• Internal 32Kbytes Memory for Tx/Rx Buffers

Features : 

1. Adopt imported controller PL2303HX, which can stabilize the flash with high speed
2. 500mA self-recovery fuse for protection.
3. Two data transmission indicator can monitor data transfer status in real time.
4. Reserve 3.3V and 5V pin interface, easy for the DDWRT of different voltage system that needs power.
5. The entire board is coated by the high quality transparent heat-shrinkable sleeve, making the PCB in insulation state from outside.
6. The electrostatic package ensures the board will not be damaged before use.
7. Support WIN7 system.

Features :

1. Operating voltage: 5V
2. On-board MAX485 chip, A low power consumption for the RS-485 communication, slew-rate limited transceiver.
3. A low power consumption for the RS-485 communication
4. Onboard then 5.08 (mm) pitch 2P terminal to facilitate RS-485 communication wiring.
5. All pins of the chip have been lead to can be controlled through the microcontroller.
6. Convenient RS-485 communication wiring
7. Multiple Units can be connected to the same RS-485 bus wiring.