Compact Optical Dust Sensor module – GP2Y1010AU0

Specifications :

1. Power: 10 W (approx)
2. Input voltage: AC 220 V
3. Working frequency : 3khz
4. Current consumption:<0.3 A
5. Ozone output capacity : 500 MG/HR

Features:

• It is 6 pins plastic socket, to match with semiconductor sensor use.
• It could be soldered on gas alarm pcb board directly, then insert semiconductor sensor onto it.
• It is more convenient than solder sensor directly on the pcb.

Specifications:

• Model :PPD42NS
• Detectable particle size approx. :1μm (minimum.)
• Detectable range of concentration: 0~28,000 pcs/liter (0~8,000pcs/0.01 CF=283ml)
• Supply Voltage: DC5V +/- 10% (CN1:Pin1=GND, Pin3=+5V)
• Ripple Voltage within 30mV
• Operating Temperature Range 0~45°C
• Operating Humidity Range :95%rh or less (without dew condensation)
• Power consumption :90mA
• Storage temperature: -30~60°C
• Time for stabilization :1 minute after power turned on
• Output Method Negative: Logic, Digital output,
• Hi : over 4.0V(Rev.2) Lo : under 0.7V
  (As Input impedance : 200kΩ) OP-Amp output, Pull-up resistor : 10kΩ

Features:

1. Power supply voltage: DC5 ± 2V
2. Sensitivity: 0.5V / (0.1mg / m3)
3. The minimum detection level of particles: 0.8 m
4. Clean air voltage: 0.9V typ.
5. Low consumption current (Icc: MAX. 20 mA)
6. The presence of dust can be detected by the photometry of only one pulse
7. Enable to distinguish smoke from house dust

Features:

1. Power requirements: 5 VDC @ ~165 mA (heater on) / ~60 mA (heater off)
2. Current Consumption: 150mA
3. Operating temperature: 14 to 122 °F (-10 to 50°C)
4. It has a long service life and reliable stability.
5. DO output: TTL digital 0 and 1 ( 0.1 and 5V)
6. AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V