Showing 37–45 of 56 results
Hobbywing Quicrun WP Brushed Electronic Speed Controller For Rock Crawlers ESC 80A
IC L293D
Kangaroo X2 Motion Controller
Specifications:
- 2 channel self-tuning PID controller
- Position or speed control
- Quadrature encoder feedback or potentiometer feedback
- 80,000 pulses/sec processing
- Support for limit switches and mechanical stops
- Analog, R/C and serial inputs
L293D Motor Driver Board for ESP8266 WiFi NodeMcu Lua ESP12E
Specification
- ESP8266 WiFi Motor Drive Expansion Shield Board For NodeMCU ESP-12E
- Motor power supply (VM):Â 4.5V ~ 36V, can be powered separately
- Control power (VIN):Â 4.5V ~ 9V (10VMAX), can be powered separately
- Module provides short-circuit sub (short the VM and VIN), you can easily use one power (must be 4.5V ~ 9V) while completing motor drive and control.
- Logic Operating current Iss: ≤60mA (Vi = L), ≤22mA (Vi = H)
- Drive part of the work current Io: ≤1.2A
L293D Motor Driver Module 4.5-25V
L293D Motor Driver/Servo Shield for Arduino
Specifications:
- 2 connections for 5V ‘hobby’ servos connected to the Arduino’s high-resolution dedicated timer
- 4 H-Bridges: L293D chipset provides 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes.
- Can run motors on 4.5VDC to 25VDC.
- Up to 4 bi-directional DC motors with individual 8-bit speed selection (so, about 0.5% resolution)
- Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil, or interleaved stepping.
- Pull-down resistors keep motors disabled during power-up
- Big terminal block connectors to easily hook up wires (18-26AWG) and power
- Arduino reset button brought up top
- 2-pin terminal block and jumper to connect external power, for separate logic/motor supplies
- Tested compatible with Arduino Mega 1280 & 2560, Diecimila, Duemilanove, and UNO
L298N Dual H Bridge DC/Stepper Motor Driver Controller Module
