Showing 529–540 of 585 results

Search results: “display ” – Page 45

HDMI Female To Female Coupler Joiner Adapter Extender Connector HDTV PC 1080P

141.60 (Inc. GST)
120.00 (+18% GST Extra)

Features:

  • This HDMI adapter is Plug and Play, no driver installation required.
  • Just plug two cables together and project the same image to two displays at a time
  • 24K Gold-plated connectors resist corrosion, provide durability, high performance and improve the signal transmission

Digital Caliper 150mm – Good Quality

1,062.00 (Inc. GST)
900.00 (+18% GST Extra)

Features:

  • Measuring Range: 0-200 mm
  • Resolution: 0.01mm
  • Accuracy: 0.02mm(<100mm) , 0.03 mm(>100-200mm)
  • Repeatability: 0.01mm
  • Max Measuring Speed: 1.5 m/s
  • Display: LCD Display

MASTECH Smart SMD Tester (R/C)

2,743.50 (Inc. GST)
2,325.00 (+18% GST Extra)

Features: 

● Display 3000 counts
● Auto Ranging
● Auto Power Off
● Data Hold
● Low Battery Display
● Auto Scanning
● Diode Check Open Voltage 2.8V
● Diode Testing Current 2mA
● Continuity Buzzer <30Ω

ESP8266/ ESP-12F Module/ Serial WIFI Witty Cloud Development Board + MINI nodeMCU

274.99 (Inc. GST)
233.05 (+18% GST Extra)

Features :

  1. LDR Light Sensor on board
  2. WS2812 Led on board
  3. 3x tactile buttons (1x in the Witty board and 2x in theCH340 board)
  4. Micro USB connection for power and/or programming
  5. Uses latest ESP-12F module with 4M flash and integrated antenna
  6. Includes CH340G USB-to-UART programmer
  7. Includes LDR (light dependent resistor a.k.a photoresistor) connected to ESP’s ADC pin
  8. RGB LED connected to GPIO 12,13 and 15
  9.  It supports 3 modes AP, STA, AP+STA

Raspberry Pi Official Mouse

716.26 (Inc. GST)
607.00 (+18% GST Extra)

Specification

The official Raspberry Pi mouse is a three-button optical mouse which connects via a USB type A connector either to one of the USB ports on the keyboard or directly to a compatible computer.

  • Three-button optical mouse
  • Scroll wheel
  • USB type A connector
  • Ergonomic design for comfortable use
  • Compatible with all Raspberry Pi products

1mm Pitch 20 Pin FPC FFC SMT Drawer Connector (Pack of 2)

29.50 (Inc. GST)
25.00 (+18% GST Extra)

Specifications:

  • Pins: 20
  • High corrosion resistance.
  • Easy to use.
  • Suitable For PCB: 1.2-1.6mm.
  • Arraying cable(FPC,FFC): 0.3mm

DC 100V 100A Voltmeter Ammeter Without Shunt

619.50 (Inc. GST)
525.00 (+18% GST Extra)

Specifications:

  • Operating Voltage: 5V DC
  • Current Consumption: <60mA
  • Testing Voltage: 0-100V
  • Testing Current: 1-100A
  • Easy to read even in dim light

SSR 5V 2 Channel Low Level Module 240V 2A Output with Resistive Fuse – G3MB-202P

289.10 (Inc. GST)
245.00 (+18% GST Extra)

Specifications:

  1. 2 channel 2 AMP Solid State Relay board
  2. Control 2 loads of up to 2 amps each at 120V or 240V AC.
  3. Good for lighting, holiday displays etc.
  4. Input control signal voltage:
    1. 0-0.5V the state of low-level relay ON
    2. 0.5-3.3V Unknown State
    3. 3.3-5V high-level relay OFF
  5. Operating Voltage: 5V
  6. Operating Current: 16mA
  7. Maximum Load: 2A @ 240VAC

CJMCU-34725 TCS34725 Color Sensor RGB Module

478.99 (Inc. GST)
405.93 (+18% GST Extra)

Specifications:

  • Operating Voltage: 3.3V
  • Supply Voltage: 3.3V-5V
  • Color management is more accurate
  • The high sensitivity
  • Wide dynamic range
  • IR shading filters make the TCS34725 ideal

CJMCU-123 WS2811 RGB LED Breakout Module

79.06 (Inc. GST)
67.00 (+18% GST Extra)

Specifications:

  • Supply Voltage: 5V.
  • Viewing angle: 120 degrees
  • The color of the light was highly consistent
  • Full-color module, Full-color soft lights a lamp strip.
  • Built-in electric reset circuit and power lost reset circuit.
  • Each pixel of the three primary colors can achieve 256 brightness levels, or 16M colors full-color display, and scan frequency not less than 400Hz/s.

LED Traffic Lights Signal Module / Digital Signal Output Traffic Light Module

49.56 (Inc. GST)
42.00 (+18% GST Extra)

Specifications:

  • PCB Size: 60 x 20 x 13.5 (LxWxH) mm.
  • Color: red, yellow, green
  • LED Size: 10mm x 7.
  • Brightness: Normal brightness.
  • Voltage: 5V.
  • Interface: common cathode red yellow green control.

XH-W3001 AC 220V 1500W Digital Microcomputer Thermostat Switch

398.84 (Inc. GST)
338.00 (+18% GST Extra)

Specifications:

  1. Rated Power (W): 1500W
  2. Rated Current: 10 Amp Max.
  3. Measurement Input: NTC10K
  4. Temperature Measuring Range: 50~110°C
  5. Temperature Control Range: 50~110°C
  6. Control Accuracy: Upto 0.1℃
  7. Measuring Accuraccy: ± 0.2 ℃
  8. Temp Probe Cable Length: 1 Meter
  9. Dimensions (mm) LxWxH: 60 x 45 x 31