5A PWM Speed Control Forward Reverse 5V 12V 24V DC Motor Driver Servo Motor Drive Board H Bridge Motor Driver Module

Specifications:

Product model: YYH-LWZ
Input voltage: DC DC5V~27V
Rated output current: 5A, can maintain continuous current within 5A
Static standby current: only about 3MA
Signal type: The control signal uses the sink current drive method, which supports the direct drive of most single-chip microcomputers, the optocoupler is completely isolated, and the PWM signal frequency supports within 20KHZ
Use fast recovery diodes to prevent excessive anti-induced electromotive force from burning out the control part when the motor starts

SKU: RDNA-343.7

Apple Shopping Event

Hurry and get discounts on all Apple devices up to 20%

Sale_coupon_15

₹1,475.00 (Inc. GST)
₹1,250.00 (+18% GST Extra)

Only 1 left in stock

Compare

Add to wishlist

11 People watching this product now!

Pick up from the RoboticsDNA Store in Pune / Dunzo

To pick up today

Free

Same Day Delivery in Pune

(Mon-Sat) (Please Place Order Before 1:30 PM)

Rs. 99

via Delhivery.com (Express Mode)

Our courier will deliver to the specified address

3-5 Days

Rs. 149

via Delhivery.com (Surface Mode)

Our courier will deliver to the specified address

4-7 Days

Rs. 69

Payment Methods:

Description

Precautions

1) The power supply of the driver must not be reversed. It is recommended to connect a 15A fuse in series at the power interface, and the voltage should be between 5V and 27V. If the voltage is overvoltage, the power-on may burn the drive module.

2) It is recommended that the rated output current of the power supply is more than twice the rated current of the motor, so as not to cause the power supply to fail to provide the current required by the motor to start, and to cause the power supply voltage to drop so that the power supply voltage cannot reach the input voltage required by the drive, so that the drive module performs under-voltage protection shutdown. If the output is cut off, the motor will stop.

3) The motor interface must not be short-circuited, otherwise the drive module may be burned. It is recommended to connect a 10A fuse in series at the motor interface.

4) The driver should be connected to the motor before powering on to prevent the driver module from being accidentally short-circuited.

5) Be careful not to get the driver wet, do not short-circuit the components on the driver board, and do not touch the pins and pads of the components on the board with your hands.