12V 24V 36 10A Motor Remote Control Switch Motor Forwards Reverse Up Down Stop Door Window Curtain Wireless TX RX Limited Switch
₹2,065.00 (Inc. GST)₹1,750.00 (+18% GST Extra)
- Working Voltage: DC 12V-36V
- Working Frequency: 433Mhz
- Receiving sensitivity: -105dBM
- Max Load: 10A Relay ( have better load less than 5A)
- PCB Size:75*58*15mm Case Size :95*62*29mm
- Function: Limit & Wire External Button
Only 1 left in stockCompare
Important Point to Note:
1. Working Voltage: DC 12V-36V
2. Working Frequency: 433Mhz
3. Receiving sensitivity: -105dBM
4. Max Load: 10A Relay ( have better load less than 5A)
5. PCB Size:75*58*15mm Case Size :95*62*29mm
6. Function: Limit & Wire External Button
7. Original State OFF, (Suddenly, the electricity was cut off, then comes again, the State still is OFF, you need manual turn it ON)
8. Out State: Momentary Latched Adjusted by the Jumper on the Receiver,
( we ship default as Latched, if you need use Momentary to change the Jumper on the Receiver ,)
9. Working way changed by jumper on pins:
- Momentary: jumper doesn’t connect any two pins. Relay: Press and hold -> On; Release -> Off.
- Toggle: jumper connects the pin T and pin S. Relay: Press -> On; Press same button again -> Off·
- Latched: jumper connects the pin L and pin S. Relay: Press -> On; Press other button -> Off.
12. When the relay is activated, the buzzer synchronize with a “beep” prompt.
13. When the receiver output state is “Latched”, we have set it 0.5s time delay for forwards and reverse, it is the Protection function.
14. We have made transmitter and receiver working together and test it before ship it,when you get it don’t need to do anything ,just install it.
15. Learning Code :
(1) Press the learning button for 1 time,the learning indicator flashes slowly,Then press the transmitter button up (first button default for forward) ,the learning indicator flash 5 times and OFF,It mean the first button learning Successfully
(2) Press the learning button for 2 times,the learning indicator flashes slowly,Then press the transmitter button down (second button default for forward) ,the learning indicator flash 5 times and OFF,It mean the second button learning Successfully (Third button default for stop ,When the jumper set for Latched)
16. Clear code : Press the learning button on the receiver for 5s,the learning indicator will flash 3 times and OFF , It mean all the transmitter code in the receiver have been cleared.
Only logged in customers who have purchased this product may leave a review.