1 Channel 5V Relay Module without Optocoupler

Features:

1. Supply voltage: 5VDC
2. Current: greater than 150mA
3. Load: 250V 10A AC or 30V 10A DC

Specifications:

1. Operating Voltage Range: 3.3V to 5V
2. Maximum Voltage: 250V AC
3. Maximum current:10 A
4. Supply Current: 150mA
5. Operating Temperature (°C): -40 to 80

Features

• One normally closed contact and one normally open contact
• Channel: 4 channel
• Relay Operating Voltage: 3.3V to 5V
• Triode drive, increasing relay coil
• High impedance controller pin
• Pull-down circuit for avoidance of malfunction
• Power supply indicator and Control indicator lamp
• Power supply and relay instructions, lit, disconnect is off;
• Input signal, signal, common Terminal and start conducting;
• Useful for appliance control;
• DC or AC signal, control, you can control the 220V AC load;
• There is a normally open and one normally close contact;
• The module is compliant with international safety standards, control and load areas isolation trenches.

Specifications:

1. Adjust the sensitivity with the potentiometer. Set the start relay threshold by adjusting the potentiometer.
2. When it is brighter, the module relay pulls in.
3. When the threshold is dark, the relay is disconnected.
4. Operating Voltage: 3.3V – 5V.

Specifications:

• Max relay voltage: 240VAC
• Max relay current: 10A @ 28VDC, 12A @ 120VAC, 10A @ 240VAC.
• Relay resistance: 100 mΩ max
• 3.5V to 5.5V operating voltage (on servo pigtail)
• 30mA typical draw from receiver

Specifications:

1. Voltage version: 5V
2. The static current: 5mA
3. Working current: 190mA
4. Trigger current: 2-4mA
5. The module can be set high level or low-level trigger by the jumper
6. Rated current of the interface is 16A