Drivers/Controllers/Testers/Electronics
₹350.46 (Inc. GST)₹297.00 (+18% GST Extra)Add to cart
₹350.46 (Inc. GST)₹297.00 (+18% GST Extra)
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
₹350.46 (Inc. GST)₹297.00 (+18% GST Extra)
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry PiSpecifications:
- Adjustable frequency PWM up to about 1.6 KHz
- 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
- Configurable push-pull or an open-drain output
- The output enable pin to quickly disable all the outputs
- Terminal block for power input
- Reverse polarity protection on the terminal block input
- Green power-good LED
₹1,353.46 (Inc. GST)₹1,147.00 (+18% GST Extra)Read more
Out of stock
₹1,353.46 (Inc. GST)₹1,147.00 (+18% GST Extra)
8 Channel Servo Controller SC08A
8 Channel Servo Controller SC08A
₹1,353.46 (Inc. GST)₹1,147.00 (+18% GST Extra)
8 Channel Servo Controller SC08A
8 Channel Servo Controller SC08A- Resolution: 8000 steps = 0.25us.
- UART: 9600 baud rate.
- Servo pulse range: 0.5ms to 2.5ms.
- Dimension : 48 x 46 x 14 (LxWxH) mm.
- 8 channels: Servo-driven independently.
- Extendable to 16 Channels: Two controllers linked together to drive 16 servos.
- Optional Position Reporting: User may request the position of an individual servo.
₹748.12 (Inc. GST)₹634.00 (+18% GST Extra)Add to cart
₹748.12 (Inc. GST)₹634.00 (+18% GST Extra)
Cellmeter 8 Multi-Functional Digital Power Servo Tester
Cellmeter 8 Multi-Functional Digital Power Servo Tester
₹748.12 (Inc. GST)₹634.00 (+18% GST Extra)
Cellmeter 8 Multi-Functional Digital Power Servo Tester
Cellmeter 8 Multi-Functional Digital Power Servo TesterSpecifications:
- Balance Discharge Current: 90mA × 8 Cell (Max@Cell Voltage 4.2v)
- Servo Test Frequency: 50Hz, 60Hz, 100Hz, 125Hz, 200Hz, 250Hz, 300Hz,
- Battery Voltage Test Precision: 0.001V
- Support Battery Type: Can test Li-Po, Li-ion, Li-Fe (2-8S), NiCd, NiMH(4-8S) battery
₹212.40 (Inc. GST)₹180.00 (+18% GST Extra)Add to cart
₹212.40 (Inc. GST)₹180.00 (+18% GST Extra)
Servo Motor ESC Tester
Servo Motor ESC Tester
₹212.40 (Inc. GST)₹180.00 (+18% GST Extra)
Servo Motor ESC Tester
Servo Motor ESC TesterSpecifications:
- Offer 3 modes to check servos or ESC
- Supply voltage: 4.8V-6.0V
- Output Signal: 1.5ms±0.5ms
- Three mode selection [Manual, Neutral and Auto]
- Enclosure Box
- Mode selection LED Indicator
- Adjustable Knob for manual speed control
- Operating Temperature Range: -40~+85°C
- The Manual Mode allows you to turn the knob to different speeds and check the reaction time
- The Neutral mode makes the servo go back to the neutral point
- The Automatic ’’Window Wiper’’ Mode makes the servo swing like a window wiper in the largest angle possible
- Connect to up to 3 servos simultaneously.
₹289.10 (Inc. GST)₹245.00 (+18% GST Extra)Add to cart
₹289.10 (Inc. GST)₹245.00 (+18% GST Extra)
Servo/PWM Driver Adafruit 16-Channel 12-bit I2C interface PCA9685
Servo/PWM Driver Adafruit 16-Channel 12-bit I2C interface PCA9685
₹289.10 (Inc. GST)₹245.00 (+18% GST Extra)
Servo/PWM Driver Adafruit 16-Channel 12-bit I2C interface PCA9685
Servo/PWM Driver Adafruit 16-Channel 12-bit I2C interface PCA9685Specifications:
- 5V compliant, and still talks to a 3.3V microcontroller
- 6 “address select” pins for configuring up to 62 ICs on a single I2C bus
- PWM frequency adjustable up to approximately 1.6kHz
- 12-bit frequency resolution (equates to about 4µs resolution at 60Hz refresh rate)
- Configurable as push-pull or open-drain output
- Output enable pin available for outside-the-microcontroller “shut it down!” control.
